Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Winston-Salem, NC

Garage Door Repair in Winston-Salem, NC

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close. Typical cost $150-$450.

Garage doors rarely fail at a convenient time. If you need garage door repair in Winston-Salem, NC, we can often come out the same day when a technician is available. Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for garage door repair

  • The door won't open or close, or stops partway
  • It shakes, jerks or sits crooked as it moves
  • Loud grinding, banging or scraping noises
  • The opener runs but the door doesn't move
  • Visible gaps, sagging or a loose cable

Common causes

  • A broken torsion or extension spring
  • Frayed or slipped lift cables
  • Worn rollers or a bent or loose track
  • Opener, sensor or remote problems
  • Hardware that has loosened over years of use

Before the technician arrives

  • Look for a gap in the spring above the door. A broken spring has a visible break in the coils.
  • Check that both photo-eye lights near the floor are steady, not blinking.
  • Make sure nothing is blocking the tracks or the door's path.
  • Check that the opener is plugged in and the wall button lights up.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle garage door repair

  1. Inspect the springs, cables, rollers, tracks, hinges and opener
  2. Explain what's wrong and give you a price before starting
  3. Replace or adjust the failed parts
  4. Balance the door and lubricate moving parts
  5. Test the auto-reverse and photo eyes before we leave

Typical garage door repair prices

$150-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Winston-Salem, NC and nearby towns

Humid air in North Carolina rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Winston-Salem (ZIP codes 27101, 27102, 27103, 27104, 27105 and more), plus Walkertown (7.3 mi), Wallburg (8.5 mi), Clemmons (9.4 mi) and Kernersville (9.6 mi). Call (833) 435-8883 to book a visit in Winston-Salem.

Garage Door Repair: frequently asked questions

How much does garage door repair cost in Winston-Salem, NC?

Garage Door Repair typically costs $150-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do garage door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is garage door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where North Carolina or Winston-Salem requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Winston-Salem, NC

Raynor Torsion Spring Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $200-$450

Amarr Garage Door Cable Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$350

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Raynor Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Martin Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Craftsman Remote & Keypad Programming

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $50-$150

Midland Garage Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Raynor Garage Door Cable Repair

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$350

Genie Smart Garage Door Opener Setup

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$900

Haas Door Extension Spring Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$350

Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Marantec Remote & Keypad Programming

Marantec is a German manufacturer of residential and commercial door openers.

Typical $50-$150

Garage door stuck, noisy or broken?

Talk to a garage door technician in Winston-Salem, NC now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote